Cutting And Grinding Discs: Matching The Abrasive To The Job
The collet and collet body hold the tungsten in place and need to match its diameter exactly. A worn or incorrectly sized collet allows the tungsten to shift slightly during welding, which affects arc stability in ways that are easy to blame on technique when the actual cause is a consumable that needs replacing. CK Worldwide and Furick are two of the ranges we stock here, and these are inexpensive parts, but neglected ones cause a disproportionate amount of frustration at the torch.
Most domestic UK properties are supplied with single-phase power, typically 230V, which is more than adequate for light-duty inverter welders used for hobby work, repairs and general fabrication. Three-phase supply, commonly 400V to 415V across three live conductors, is standard in industrial premises and delivers power more efficiently to heavier equipment, which is why higher-output welders and plasma cutters, including some Fronius and ESAB machines, are often offered in a three-phase version.
Matching duty cycle to actual workload, rather than just chasing the highest amperage figure, is the difference between a machine that keeps up with the job and one that keeps tripping out halfway through it, and it's a question worth raising with a supplier before you buy, such as Tec Products Ltd.
For anyone starting out, talking through process, budget and set-up with people who deal with first-time buyers regularly is generally worth more than another hour of reading spec sheets, and that's exactly the sort of conversation the advice line at Tec Products Ltd is there for.
Portability and durability matter depending on how the table gets used. A shop building large frames or vehicle chassis needs a solid, well-supported table that won't flex under load, while a mobile fabricator or someone working across multiple sites benefits more from a lighter, foldable design. Material and construction quality affect long-term flatness too, since a table that warps under heat from repeated welding stops being reliable exactly where it matters most.
Abrasive discs look interchangeable on a shelf but perform very differently depending on what they're made from and what they're used on. Cutting discs are generally thin, designed to slice through material quickly with minimal heat build-up, while grinding discs are thicker and shaped to remove material from a surface or clean up a weld, rather than cut all the way through it.
